Projects
Selected projects and builds. This page is intentionally lightweight — it’s a snapshot, not a portfolio dump.
3D-printed bird feeders
Outdoor-ready design with attention to tolerances, assembly, and repeatability.
Notes
Designed in SolidWorks as part of a solid modeling course. Built to survive real use and weather — not just look good on a desk.
Double Ferris wheel (MAT 220)
A trigonometry project turned into a physical mechanism.
Notes
Built during a trigonometry semester — translating concept into structure and assembly.
Wearable armor build
Fit, alignment, finish, and iteration — a “systems problem” in physical form.
Notes
A long-term build with iterative improvements. The same mindset applies: stabilize the foundation, then optimize.
Want a deeper project breakdown? Easiest route: message me on LinkedIn.